How do I light my log fired Stove?

A log is blazing away looking very warm and hot

Getting your stove lit properly makes all the difference – giving a quicker start, less smoke and a more efficient burn.

Always follow the lighting instructions provided by your stove manufacturer. Alongside these, we’ve included two tried and tested methods that we recommend: the Traditional Method and the Upside Down Method.

The Traditional Method

1. Start with a Bed of Ash
Leave about 1cm (½–1”) of ash from your previous fire. Wood burns best on a thin layer of ash, while coal likes a clean grate – so this trick is just for log burners.

2. Paper, Firelighters and Kindling

  • Scrunch up a few sheets of newspaper to cover the base, or break up a firelighter into small pieces.

  • Stack dry kindling on top in a criss-cross fashion – use plenty. The gaps let air flow through, helping everything catch quickly.

3. Open the Vents
Make sure all air controls are fully open before lighting. Ignite the newspaper/firelighters in several spots to get an even burn.

4. Add Small Logs
Place a small log or two on top of the kindling. Don’t force or push them in – stove liners (vermiculite bricks) are delicate and can crack if knocked.

5. Get the Fire Established
You can leave the door slightly ajar for a minute or two to boost airflow. Once the kindling is roaring, close the door.

  • The goal is for the logs to catch with glowing edges and a steady flame.

  • Keep vents open until this happens, then gradually reduce the airflow.

6. Aim for a Lazy Flame
You want to see several small, steady flames dancing on the logs – not roaring, not dying.

  • Too little air = smoky, sluggish fire.

  • Too much air = over-firing, which wastes fuel and can damage the stove.

7. Use the Vents Correctly
Most stoves have two controls:

  • Close the primary vent once the fire is established.

  • Use the secondary vent to maintain the flame and keep the glass clean.

8. Reloading the Fire
Wait until you’ve got a glowing bed of embers before adding more logs.

  • Open the vents first, then crack the door slightly for a few seconds – this prevents gases escaping into the room.

  • Add fresh logs gently, then close the door.

  • Check your stove handbook for the correct reloading rate – every model is slightly different.

The Upside Down (Top Down) Method

This method replaces Steps 2-4 above.

Commonly used in Scandinavian countries, this method places the flame at the top of the fuel stack rather than the bottom. This helps warm the flue more quickly, improving the chimney draw and establishing a cleaner, more efficient fire.

  1. Place two small logs on the fire bed.
  2. Lay a handful of kindling across the logs (around five pieces).
  3. Continue adding 3 to 5 layers of kindling, alternating each layer at 90°. Most stoves (around 50 cm high) will comfortably take 4 layers.
  4. Place one firelighter on top of the stack.

Top tips:

  • Place a second firelighter in the centre of the stack for easier lighting.
  • Leave small gaps between the kindling to allow airflow.
 

How Long Does It Take?

From match to reload stage usually takes around 30–40 minutes.

The Bottom Line - Always Have A Flame

Always keep a flame going. A healthy, steady flame gives you clean combustion, maximum heat, and less mess in your flue. Once you’ve mastered the technique, lighting your stove becomes second nature.