Sometimes bends are unavoidable. Here’s when we use them, the difference between 45° and 90°, and what each option costs.
Twin Wall Flue Bends
Sometimes a flue can’t run perfectly straight. Joists, rafters, soffits, or other obstacles can mean a slight offset is needed. That’s where bends come in.
Types of Bends
45° Bends – the most common option. Usually fitted in pairs (one to offset, one to bring the flue back).
15° and 30° Bends – used where a shallower offset is better for performance. We carry full sets of bends to site so we can choose the best route. A gentler dogleg helps the flue draw more efficiently.
90° Bends / Tee – rarely recommended. Only used at the base of an external system.
135° Tee – standard fitting at the bottom of an external flue system. Includes a drain cap to clear condensates and soot.
Typical Uses
Internal flues (bungalows or two-storey runs):
Used to clear joists and rafters where a straight rise isn’t possible.
External flues:
To pass through external walls, then connect back into a 135° Tee at the base for safe cleaning and drainage.
To kick the system out past soffits or guttering if they sit offset from the wall.
Pricing
Pair of vitreous bends (on stove pipe): ~£100
Pair of chrome twin wall bends: ~£180
Pair of black twin wall bends: ~£200
We may have to use an extra support – to support the bends. The supports vary from £25 – £100.
Installer’s Note
We always aim to keep flues straight – it tends to look better and keeps costs down. Bends are only used where absolutely necessary, and always in line with HETAS regulations.
A straight run also performs better; it draws better, is easier to sweep, and avoids unnecessary pressure drops. Doglegs and offsets reduce the natural flue draft (the chimney effect) and weaken the venturi effect at the top, so we only bend the system when the building layout leaves no other option.