Problems & Safety Considerations

Not every fireplace opens up cleanly – hidden problems need fixing before a stove can go in.

Opening up a fireplace can reveal more than just rubble.

Damp patches, old back boilers, old school metal bar lintels (see above), blocked flues, or unsafe gas and electric setups are all things we come across.

None of these are surprises to us – but they can add extra work, and they need to be dealt with properly to keep your stove safe and compliant.

Damp in the Fireplace

Moisture problems are one of the most common issues we find when opening up old chimneys. Sometimes it shows straight away, sometimes it only appears months later.


→ Read more about damp in fireplaces

Old Back Boilers

A back boiler is a small water-heating unit that was fitted behind an open fire or fireplace. It used the heat from the fire to warm water for central heating or hot water tanks.

It’s not unusual to find a disused back boiler hidden behind a fireplace. These were often left capped off when homes switched to modern central heating systems, but they can still be dangerous if disturbed.

  • They may contain water or pressure that was never fully released.

  • Old pipework can be corroded or unsafe.

  • If the system is still live and the boiler is connected, a qualified plumber must be involved to isolate and drain it properly.

  • If a back boiler is accidentally damaged while live, a large volume of water can be released without warning.

A back boiler must always be properly decommissioned and removed before any stove installation goes ahead. If we discover one, work stops until it’s dealt with safely. We can strip them out and make the fireplace good, but it does add to the job.

Old School Metal Bar Lintels

Some older fireplaces were only supported with slim steel bars across the top rather than a proper lintel.

  • They were common at the time, but don’t offer reliable long-term support.

  • Part of our work is replacing them with a new concrete lintel (or granite where the design calls for it).

  • Without this, the brickwork above the fireplace isn’t properly supported.

It’s a straightforward upgrade, but an essential one for safety.

Gas & Electric Fires

If you’re converting from gas or electric, safe disconnection is critical.

  • Gas supplies must be isolated and signed off by a Gas Safe engineer.

  • Old electric fires and wiring need removing and making safe.

  • Once cleared, the opening can be prepared just like any other fireplace.

This step protects you from hidden risks and ensures the fireplace is stove-ready.

Blocked or Damaged Flues

From rubble and birds’ nests to collapsed clay liners, blockages can stop a flue being safe or usable. In simple cases they’re cleared easily, in others it takes more work.


→ Read more about blocked or damaged flues

Multi-fuel & Smokeless Fuel Issues

Smokeless fuels can cause serious wear to stoves and liners if not used carefully. We’ve seen parts fail early, liners corrode, and even stoves written off.


→ Read more about smokeless fuel issues

Safety First

Every installation we carry out is built to Building Regulations and certified through HETAS. Problems are flagged early and dealt with properly, so nothing is hidden or ignored.

We can’t always see everything in advance – much of the chimney is hidden until we start the work. But we know the common culprits, what to look for, and how to deal with them. Hopefully you’re more aware of these potential problems now too.